Scanning doesn’t stop on active station

SDRPlay Independent Community Forum Forums SDRUno Scanning doesn’t stop on active station

  • This topic has 1 reply, 2 voices, and was last updated by .
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #784
    Burch
    Participant

    Hello

    I am new to SDRplay and am using SDRuno. I live near the coast and have programmed many of the VHF marine channels into the software. When I select MEM scan mode and scan, the software doesn’t stop on an active station. I am sure I am doing something wrong but I can’t figure it out. Any help would be greatly appreciated.

    Burch

    #786
    Andy2
    Participant

    IIRC, you have to open up the scanner config panel (page 13 user manual) and then you can set the threshold above which the scanner reacts to signals. If this is set too high, the scanner won’t stop.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.