[RSP-Duo] dump1090 on Tuner 1 issue

SDRPlay Independent Community Forum › Forums › SDR Software (RSP Compatible) › [RSP-Duo] dump1090 on Tuner 1 issue

  • This topic has 0 replies, 1 voice, and was last updated by .
Viewing 1 post (of 1 total)
  • Author
    Posts
  • April 26, 2022 at 1:01 pm #2065
    Gremlin
    Participant

      Hello!

      i’m using a RSP-Duo. if i start dump1090 it will use Tuner 2 by default.
      this is working without any problem.

      i have an active antenna for shortwave, so i want to use receiver 2 for bias-t and use tuner 1 for ADSB.

      if i start dump1090 with the commandline switch (–rspduo-tuner1) it starts but stops working after a few seconds. no crash, it simply stops any output.
      i can quit with CTRL-C as usual.

      any hints?

      if running dump1090 on tuner 1, sdruno starts as expected as slave on tuner 2 and is running without any problems.

      Lenovo T420
      Windows 7

      Regards
      Ralf

    • Author
      Posts
    Viewing 1 post (of 1 total)
    • You must be logged in to reply to this topic.