Odd tuning behaviour

SDRPlay Independent Community Forum › Forums › SDRUno › Odd tuning behaviour

  • This topic has 3 replies, 2 voices, and was last updated by .
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 11, 2021 at 4:24 pm #1680
    merlinmaxwell
    Participant

      I can’t work this out, when tuning with the mouse wheel I get a “mirror image” tuning display on the waterfall. This happens on both my DUO and DX and at any frequency antenna selection, attenuation level, low IF or zero IF, or modulation type. Best to look at the image attached.

      I am using Win 10 insiders preview.

      Attachments:

      1. Screenshot-2021-02-11-162144.jpg

      February 11, 2021 at 4:25 pm #1682
      merlinmaxwell
      Participant

        BTW never noticed it before, I think I would have. I am also using the same hardware as before I noticed it.

        February 12, 2021 at 9:22 am #1683
        Andy2
        Participant

          Hi Merlin, fancy seeing you here!
          If you have recently updated the SDRUno software, try doing a ‘reset to factory settings’ via the OPT menu. When I went from v1.3 to 1.4 I had a number of weirdos going on, including gross overloading at any gain setting and malfunctioning controls. A reset put it all right. If it’s a no-go, a quick support ticket via the main website will get some attention.

          February 12, 2021 at 12:18 pm #1684
          merlinmaxwell
          Participant

            Many thanks, the reset did the trick.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.