Custom Scanner won’t run

SDRPlay Independent Community Forum Forums SDRUno Custom Scanner won’t run

  • This topic has 2 replies, 3 voices, and was last updated by .
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #502
    Lloydc
    Participant

    Hello,

    ​I am trying to set up a custom scanner for the Australian UHF channels, These frequencies are in the UHF Band between 476.4250 and 477.4125 MHz. Frequency spacing is 12.5KHz

    ​But after entering the required parameters, I can select to start scanning, and whilst it states it is scanning, I cannot see it stepping through like I can with the preset scanner options.

    ​Have attached a screen shot, any assistance greatly appreciated.

    ​Regards

    ​Lloyd

    #504
    Andy2
    Participant

    I see you have not ticked the ‘show threshold’ box. Do you know if you have set the threshold correctly? If it’s too low the scanner won’t run.

    #505
    HandymanUK
    Participant

    Also push the RF gain to the top having it that low will also stop the scanning.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.