Custom Scanner won’t run

SDRPlay Independent Community Forum › Forums › SDRUno › Custom Scanner won’t run

  • This topic has 2 replies, 3 voices, and was last updated by .
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 1, 2020 at 12:28 am #502
    Lloydc
    Participant

      Hello,
      ​
      ​I am trying to set up a custom scanner for the Australian UHF channels, These frequencies are in the UHF Band between 476.4250 and 477.4125 MHz. Frequency spacing is 12.5KHz
      ​
      ​But after entering the required parameters, I can select to start scanning, and whilst it states it is scanning, I cannot see it stepping through like I can with the preset scanner options.
      ​
      ​Have attached a screen shot, any assistance greatly appreciated.
      ​
      ​Regards
      ​
      ​Lloyd

      Attachments:

      1. SDRuno-Sacnner-Issue-Image-scaled.jpg

      January 1, 2020 at 1:07 am #504
      Andy2
      Participant

        I see you have not ticked the ‘show threshold’ box. Do you know if you have set the threshold correctly? If it’s too low the scanner won’t run.

        January 1, 2020 at 2:15 pm #505
        HandymanUK
        Participant

          Also push the RF gain to the top having it that low will also stop the scanning.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.