Reply To: How to use my RSPduo w/ Rpi-3 & command line?

[alanmalkParticipant]

You have managed to have every problem that there is with the PI.

If everything just worked – well, that wouldn’t be much of a challenge. Like using my Mac…

I was hoping you can point me towards some instructions for sdrTest. Specifically,
what some of the parameters control. For example, I see -fc and -f but really
don’t understand the difference. I observe they are close in frequency but to say
what the 400000hz difference means would be a total guess on my part. Would also
like to control the sample rate, the gain in db, etc.

And alsoft-conf is a possibility but will have to research how it interacts with my
current audio board (a little class D amp with an I2S interface.) As I said earlier,
“what could possibly go wrong” !!! 🙂